Request a Sample
Your Sample Request
Freeze Spray
*=required field
Freeze Spray
Freeze Spray is engineered for locating thermal intermittent electrical components and cooling printed circuit boards. This circuit refrigerant system is nonflammable, residue-free and provides fast cooling action.
Features & Benefits
- Quickly and efficiently cool large areas, ideal for fast thermal cycling
- Rapidly cools components to -60°F/-51°C
- Non-abrasive, safe for use on plastics and other sensitive surfaces
- Ultra pure, filtered to <0.2 microns
- Nonflammable
- CFC/HCFC free
- Evaporates quickly
- Leaves no residue
Applications
- Cool Equipment for Testing
- Dissipate Heat While Soldering or Desoldering
- Isolate Thermal Intermittent Components
- Test Circuit Traces for Continuity and Stress Fractures
- Track Intermittent Failures and Shorts
| TDS | |
| MSDS (ANSI) |
|
| SDS (GHS) | |
| Categories |
| Specifications | Fed Spec A-A58060, ARI Standard 700 |
|---|---|
| Shelf Life | 10 yrs. |
| Shipping Name | Consumer Commodity ORM-D |
Articles
Ultimate Guide to Diagnostic Freeze Spray
Diagnosing and repairing electronics can be painstaking and sometimes frustrating work. Problems can be intermittent, with the faulty area on the PCB difficult to locate. Freeze spray is an essential tool, because it helps identify faulty components, solder joints, and other problems that can lead t...
Read This Post
Products Engineered to Reduce Climate Change Impact
As the impact of greenhouse gases on the global climate becomes more apparent, companies are seeking to reduce the carbon footprint of their operations. In anticipation of this, the Chemtronics R&D team has been hard at work developing new products with much lower Global Warming Potential (GWP...
Read This Post
Ultimate Guide to Cleaning Electronics
In the process of assembling, reworking or repairing printed circuit boards (PCB) for electronic devices, the discussion inevitably turns to whether or not to clean the PCB. Cleaning adds time and expense to the process, and doing it wrong can cause more harm than good. This guide will walk yo...
Read This Post
Why Flux Pens Make PCB Repair Easier
Flux is needed to prevent oxidation that tends to form when hot metals come in contact with the air. During printed circuit board repair and soldering, it's common to see liquid flux from the wave soldering equipment poured into jars and applied with an acid brush. More is better, right?...
Read This Post
